Wobbler Engine Adjusting Nut

Published by Tim on

This is the 13th in our series of posts where we are sharing drawings for the White Horse CAD Wobbler Engine. This week we will look at the Wobbler Engine Adjusting Nut.

Next week we will look at the Wobbler Engine Drive Shaft.

Lets look at the Wobbler Engine Adjusting Nut in a little more detail. If you would like to refer to the PDF engineering drawing it can be found by clicking here… P9999-11104_Rev 1

The Wobbler Engine Adjusting Nut is another straight forward component. It’s purpose is  ensure the piston block is pulled against the main support with a predefined force.

Disclaimer
This project has never been made. For that reason, White Horse CAD are not able to offer any warranty or guarantee that the plans can be used to build a working engine.
This series of engineering drawings is intended to demonstrate capability in using SolidWorks. If anyone manufactures a version of this engine White Horse CAD shall not be held responsible for errors or omissions in the drawings

Don’t miss the next in the series… … sign up here…
Have a project you would like to discuss?… Contact us here…

Categories: Wobbler Engine Plans

Related Posts

Wobbler Engine Drive Shaft

This is the 14th in our series of posts where we are sharing drawings for the White Horse CAD Wobbler Engine. This week we will look at the Wobbler Engine Drive Shaft. Next week we Read more…

Wobbler Engine Piston Block Washer

This is the 12th in our series of posts where we are sharing drawings for the White Horse CAD Wobbler Engine. This week we will look at the Wobbler Engine Piston Block Washer. Next week Read more…

Wobbler Engine Piston Block Stud

This is the 11th in our series of posts where we are sharing drawings for the White Horse CAD Wobbler Engine. This week we will look at the Wobbler Engine Piston Block Stud. Next week Read more…